en English
You do not have permission to see this content.

Tips For Choosing Water Chiller Models

Users of a laser machine should take consideration into the following factors when choosing the appropriate water chiller model. here are some suggestions:

Tips 1

Make a choice according to laser tube power and the actual working status of the laser machine.

The high temperature will cause damage to the laser tube and decrease the laser power output. The lasting high temperature will shorten the lifespan of the laser tube. So The high-power water chiller should be considered when the machine is equipped with a high-power laser tube. 

Tips 2

The surrounding temperature when the machine works.

When the working temperature is below 10℃,water chiller will start the low-temperature protection function (most of the water chillers have such function)and the cooling fan will stop working. So we should pay more attention to the high-temperature situation, high-power water chiller should be considered when the surrounding temperature is too high.

Tips 3

The specific demands for cooling the water temperature when the laser machine works. 

The water temperature has slight fluctuation when using a high-power water chiller compared with a low-power chiller, which is favorable to the stable laser power output.

water chiller

Tips 4 ALARM DESCRIPTION

Causes of the cooling water circulation alarm and the working condition table.

TIPS 5 MAINTENANCE

1. To ensure good heat dissipating, please open the lid to clean the dirt after the chiller is used in long-term.

2. Users in cold area should use noncorrosive antifreeze fluid

3.Method of exchanging water in the water tank:Drain the waste water out of the water tank through the drain outlet and fill the clean water into the tank through the flling hole.

4.Exchanging Frequency

The circulating water should be exchanged every 3 months. The quality of the circulating water will directly influence the service life of the laser tube.It is recommended to use purified water or clean distlled water.

TIPS 5 CONNECTTION WITH LASER MACHINE

Water outlet of the water tank connects to water inlet of the laser machine while water inlet of the water tank connects to water outlet of the laser machine. Aviation connector of the water tank connects to the aviation connector of the laser machine.

Leave a Comment

Your email address will not be published. Required fields are marked *

3 × three =

Ask For A Quote

Open chat